Power Gear Leveling Jack Control Retract Jack Light on UPDATED

one- Introduction:

Electric Retract Landing Gear Controller

Thank you for choosing the Airplane pilot-Rc Electric Retract Landing Gear Controller. Designed to operate equally easily every bit possible the electric retract systems in your model aircraft. This particular unit is able to control the retracts, brakes and upward to iii gear doors.

SPECIFICATIONS AND FEATURES:

Operating voltage: vii.4v – 8.4v (Directly from 2s Lipo bombardment)
Low voltage cut off: Machine gear down if bombardment drops below 7.4v
Controls gear, brakes and up to three gear doors
Fine tuning available for the electric brakes to assure a directly line upon braking
Four options for gear door sequencing
Optional ABS braking
Safety feature: "Gear Up" incorporates a four second delay before gear is actually retracted. During this time an audible buzzer is activated warning the user of the imminent retraction of the gear, assuasive time to contrary the process if due to an accidental "Gear Up" while still on the ground.

Included hardware:

One Electric Retract Landing Gear Controller
Patch leads

Alert:

Do not exceed the maximum voltage of 8.4v or equivalent 2s Lipo

2- Installation and setup

INITIAL INSTALLATION AND SETUP:

Setup two channels on your radio with the desired switches/sliders to command each channel (one for the retracts and one for the brakes)
Set both channels terminate signal travels to -100% and +100%
Locate on the Electric Retract Landing Gear Controller the Radio inputs for Gear and Brake, and connect to the respective receiver channels ready up in step 1 using the patch leads provided.
Connect the Retract leads and Brake leads to the Electric Retract Landing Gear Controllersrespective outputs.
Fine tuning of the brakes can be achieved using the + and – buttons to assure a linear braking of the model.
Button the exam button for a few seconds, this will wheel the gear past either retracting or extending. You can utilise this testing push at any time, allowing for like shooting fish in a barrel gear up after you have finished flying for the solar day.
Please note that the testing button is designed to work only when the receiver is turned OFF.
Make sure that the gear operating direction is correct. The gear should go from extended to retracted shortly after the aural alert. If the gear is up and goes down later on audible alarm, delight reverse the connector for the Retract leads (opposite the polarity)
Can also be confirmed past the incorporated condition LED: Red is retracts up, green is retracts downwards.
Alarm. If the input voltage drops to vii.4v or less, the gear will automatically extend for a safety landing position. An audible buzzer volition also buzz repeatedly and continuously alarm of this low battery status.

Electric Retract Landing Gear Controller inputs and outputs

GEAR DOOR SEQUENCER:

Select the desired gear door movements from the four options below, and motion the sliders following your called diagram.

Please annotation that the signals for Gear Door 1 and Gear Door ii are opposites, which should suite about installations. If all the same you require both Gear Door actuators to work in the same management, please simply use a Y lead and take both signals from the same port.

The controller tin non adjust the end points of the Gear Doors, for this please keep to adjust mechanically using different length servo arms, push rods or control horns to obtain the required travel.

Gear door sequences

3- Disclaimer

All Pilot-RC products are guaranteed against defects for 30 days of your receiving the model. This warranty is limited to construction or product defects in both textile and workmanship, and does not cover whatever parts damaged due to misuse or modification.

Should you lot wish to render this production for any reason, all aircraft costs are the responsibility of client.

If any parts are needed to be replaced by the manufacturer, the original parts must be returned, at the costumers expense.

The manufacturer can not supervise the associates and maintenance of the this product and therefore tin not be made responsible or liable for any damage occurring during its use. Equally such all responsibility for the correct build, maintenance and functioning must be accepted by the customer. The operation of the model is taken as acceptance by the customer of the above.

In no event does Pilot-RC accept any liability to exceed the original toll of the bones Pilot-Rc product in question.

To ensure safety, delight read the instruction manual thoroughly before associates.

Airplane pilot-RC reserves the correct to update the model, instructions and limited warranty without detect.

If you have any problems and questions, delight contact Pilot-RC:

Web: www.Pilot-Rc.com
Email: pilot-rc@139.com, info@pilot-rc.com
Phone: +86 760 88781293 FAX: +86 760 88780293
Address: No34, Chengnan Er Road, Zhongshan City, 528455, Guangdong, Province, China.